Bostitch CAP1645-OF Bedienerhandbuch PDF herunterladen (Seite 10)

toitsend.Attachadditionallengthsofhoseasneeded.Alwaysuseaminimum3/8"(9.5mm)or

greater air hose rated at 300 psi.

VOLTAGE AND CIRCUIT PROTECTION

Refer to the Voltage and Minimum Branch Circuit Requirements underPump/Motor

Specifications.

Risk of Overheating. Certain air compressors can be operated on a 15 amp

circuit if the following conditions are met.

• VoltagesupplytocircuitmustcomplywiththeNationalElectricalCode.

• Circuitisnotusedtosupplyanyotherelectricalneeds.

• Extensioncordscomplywithspecifications.

• Circuitisequippedwitha15ampcircuitbreakeror15amptimedelayfuse.

NOTE: If compressor is connected to a circuit protected by fuses, use only time delay

fuses.Timedelayfusesshouldbemarked“D”inCanadaand“T”intheUS.

If any of the above conditions cannot be met, or if operation of the compressor repeatedly

causes interruption of the power, it may be necessary to operate it from a 20 amp circuit. It is

not necessary to change the cord set.

COMPATIBILITY

NOTE: Always use an air line filter to remove moisture and oil vapor when spraying paint.

LOCATION

Place the air compressor in a clean, dry and well ventilated area at least 12" (30.5 cm) away from

thewallorotherobstructionsthatwillinterferewiththeflowofair.Keepthecompressoraway

fromareasthathavedirtand/orvolatilefumesintheatmosphere.Theseimpuritiesmayclogthe

intake filter and valves, causing inefficient operation.

The air compressor pump and shroud are designed to allow for proper cooling.

The ventilation openings on the compressor are necessary to maintain proper operating

temperature. Do not place rags or other containers on or near these openings.

Place the air compressor on a flat surface resting on the wheels and rubber foot.

ELECTRICAL

Refer to all safety instructions before using unit. Observe extension cord safety instructions,

ifnecessary.AlwaysmovetheAuto/Offswitch(L)totheOFFpositionbeforeremovingtheplug

from the outlet.

TRANSPORTING (FIG. 3)

When transporting the compressor in a vehicle, trailer, etc.,

make sure the tank is drained and theunitissecuredwithstrapstopreventtipping.Use

care when driving to prevent tipping the unit over in the vehicle. Damage can occur to the

compressor or surrounding items if the compressor is tipped.

LIFTING (FIG. 3A)

Risk of injury from lifting

FIG. 3A

Always use two people when lifting and lift from the

recommendedliftpoints(N).DO NOT lift by

wheels or shroud.

MOVING (FIG. 3B)

1. Grasp handle (B) to support compressor.

2.Pull handle (A) until fully extended (lock position).

Risk of unsafe operation. Ensure proper

footing and use caution when rolling compressor so that

unit does not tip or cause loss of balance.

3. To move, roll compressor on tires using handle (A)

as shown above.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 52 53

Kommentare zu diesen Handbüchern

Keine Kommentare

Bostitch CAP1645-OF Bedienerhandbuch Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Luftkompressoren Bostitch CAP1645-OF