Bostitch N88RH Spezifikationen PDF herunterladen (Seite 4)

N88RH-2MCN TOOL SPECIFICATIONS

All screws and nuts are metric.

FASTENER SPECIFICATIONS:

N88RH-2MCN (with standard framing contact arm installed)

Uses a 21° plastic collated full round head stick nails, in lengths of 2” to 3-1/2” (50-90mm) and shank diameters of .113” to

.162” (2.8 - 4.1mm)

N88RH-2MCN (with metal connector attachment installed)

Uses a 21° plastic collated full round head metal connector nails, in lengths of 1 1/2” and 2-1/2” (38 - 64mm) and shank

diameters of .131”, .148” and .162”.

Use only one stick of metal connector nails at a time.

TOOL AIR FITTING:

This tool uses a 1/4” N.P.T. male plug. The inside diameter should be .275” (7mm) or larger. The fitting must be capable of

discharging tool air pressure when disconnected from the air supply.

OPERATING PRESSURE:

70 to 120 p.s.i.g. (4.9 to 8.4 kg/cm

). Select the operating pressure within this range for best fastener performance. DO NOT

EXCEED THIS RECOMMENDED OPERATING PRESSURE.

AIR CONSUMPTION:

The N88RH-2MCN requires 7.5 cubic feet per minute (212 liters per minute) of free air to operate at the rate of 100 nails

per minute, at 80 p.s.i. (5.6 kg/cm

). Take the actual rate at which the tool will be run to determine the amount of air

required. For instance, if your fastener usage averages 50 nails per minute, you need 50% of the 7.5 c.f.m. (212 liters per

minute) which is required to operate the tool at 100 nails per minute.

OPERATION

SEQUENTIAL TRIP

The Sequential Trip requires the operator to hold the tool against the work before pulling the trigger. This makes accurate

fastener placement easier, for instance on framing, toe nailing and crating applications. The Sequential Trip allows exact

fastener location without the possibility of driving a second fastener on recoil, as described under “Contact Trip”. The

Sequential Trip Tool has a positive safety advantage because it will not accidentally drive a fastener if the tool is

contacted against the work – or anything else – while the operator is holding the trigger pulled.

MODEL IDENTIFICATION:

Refer to Operation Instructions on page 4 before proceeding to use this tool.

SEQUENTIAL TRIP

Identified by:

GRAY TRIGGER

MODEL

TOOL

LENGTH HEIGHT WIDTH WEIGHT

ACTUATION

N88RH-2MCN Sequential Trip 19-7/8” (505mm) 14-3/4” (375mm) 4-7/8” (124mm) 8.2lb. (3.7kg.)

1 2 3 4 5 6 7 8 9 ... 39 40

Keine Kommentare

Bostitch N88RH Spezifikationen Seite 4